News

Hand Shower Installation Tutorial

Jul 21, 2024 Leave a message

1. Prepare the tools
1. Hand shower and accessories

2. Rubber gasket

3. Wrench

4. Adhesive tape

Second, the installation steps
1. After preparing the tools, turn off the main water source.

2. Use a wrench to unscrew the fixing nuts on the old shower and water pipe, and then unscrew out the shower bracket.

3. Install the rubber gasket under the shower base, then snap the shower base into the water pipe and tighten the fixing nut.

4. Insert the hand shower into the base of the shower and wrap the socket a few times with tape to increase the sealing.

5. Open the main water source, test whether the water flow is smooth, and confirm that there is no water leakage, that is, the decoration is completed.
3. Precautions
1. Before installation, it is necessary to pay attention to protect the water pipe interface, because the water pipe interface is often a relatively fragile place, and improper handling will cause accidents.

2. During the installation process, it is necessary to install sealing materials such as gaskets and tapes to ensure the tightness of the installation process and avoid problems such as water leakage.

3. When using tools such as wrenches, you need to pay attention to the strength and do not use excessive force to avoid damaging the water pipes or other accessories.

In short, the installation of a hand shower is relatively simple, as long as you pay attention to the details and follow the correct installation method, the installation process can be easily completed and it is very convenient to use. Hope this article was helpful to you.

 

Send Inquiry