1. * Step: Take out the basin faucet, check whether all the accessories are complete, be sure to remove the dirt around the installation hole and the water supply pipeline before installation, and ensure that there are no impurities in the basin faucet water inlet pipeline. In order to protect the surface of the faucet from scratches, it is recommended to wear gloves for installation.
2. Step 2: Take out the rubber gasket of the basin faucet, the gasket is used to relieve the pressure of the metal surface of the faucet in contact with the ceramic basin, protect the ceramic basin, and then insert a water inlet pipe and tighten it.
3. Step 3: Thread the threaded connector into the * water inlet hose, and then pass the water inlet end of the second water inlet hose through the threaded joint.
4. Step 4: Screw the second inlet hose into the inlet port, pay attention to the correct direction, balance the force, and then tighten the threaded joint.
5. Step 5: Thread two water inlet hoses into the white rubber pad.
6. Step 6: Put on the lock nut to fix the faucet.
7. Step 7: Then tighten the sleeve.
8. Step 8: Lock the interface between the two water inlet pipes and the angle valve respectively, and do not twist the pipe wrench with all your strength to prevent deformation or even torsion. Pay attention to the connection of hot and cold water. Connect the outlet angle valve with the other end of the inlet pipe.